TEMPLADOULTRA

Electrode designed especially for restoring cutting edges to  dies, augers, sheers, drilling tools, etc. (responds to Series M2 heat–treating procedures.

IDENTIFICATION: Printed Electrode

 

APPLICATION: Arc Welding AC or DC Reverse Polarity

 

SUPERIOR ADVANTAGES:

• Reduces cutting tool replacement costs dramatically
• Super-hard deposit retains a sharp edge  longer
• No heat-treating required
• High resistance to heat; up to 1,150 °F (621 °C). Cutting or drilling tools can be made using low-cost, easily machinable steel and  overlaying
• Resists high-shock conditions better than tungsten carbide

TECHNICAL INFORMATION:

Hardness: Rc 60-63 as welded; Rc 63-64 as tempered Preheat according to base metal requirements

 

USAGE PROCEDURE:

Clean materials to be restored and resurfaced of grease, scale or loose particles. Preheat large or complex sections 500 °F (260 ° C to 427 ° C), or according to  base metal requirements. To obtain best results, deposit weld metal two or three inches, peen to relieve stress and continue same process until completed. Remove slag between beads. Post heating on large sections is recommended.

 

APPLICATIONS:

• Re-edging dies
• Paper cutter blades
• Metal shears
• Drills and augers
• Punches and piercing tools
• Chisels

 

TEMPLADOULTRA
SIZE	AMPS	PART NO.
3/32  2.38	60-80	6770
1/8  3.17	95-125	6771